Grizzly G0614 Manual do Utilizador descarregar pdf (Página 34)

-32-

G0613/14 Swivel Mast Metal Cutting Bandsaw

Blade Change

Change the blade when it becomes dull, damaged,

or when you are using materials that require a

blade of a certain type or tooth count.

To change the blade on the bandsaw:

1. DISCONNECT THE BANDSAW FROM

POWER!

2. Raise the bow of the bandsaw for access

and close the feed

control lever to hold the

bow in place

3. Slide the blade guides as far apart as possible,

and remove the wheel access cover.

4. Remove both of the blade guide guards

(Figures 34 and 35) from the bandsaw.

Figure 34. Installed blade and guide guard.

5. Loosen the blade tension handle in Figure 33

and slip the blade off of the wheels.

6. Install the new blade through both blade guide

bearings and around the bottom wheel.

Tip: This is a good time to adjust the blade

guides if you have not done so recently.

Figure 35. Installed blade and guide guard.

7. Hold the blade around the bottom wheel with

one hand and slip it around the top wheel with

the other hand, keeping the blade between

the blade guide bearings.

Tip: You can use a block of wood to tap

on the blade in order to fully seat the blade.

Note: Do not to flip the blade inside out so the

blade will be installed in the wrong direction.

Make sure the blade teeth are facing toward

the workpiece and the direction of cut.

CUTTING HAZARD!

Blades are sharp! Put

on heavy leather gloves

when handling a blade

or making adjustments

near a blade or cutter

Blade Guide Guard

Guard Screws

Blade Guide Guard

Figure 33. Blade tension handwheel and

tensioner, and bow lift handle.

Blade Tension

Handwheel

Tensioner

Bow Lift Handle

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 67 68

Comentários a estes Manuais

Sem comentários

Grizzly G0614 Manual do Utilizador Página 34

Comentários a estes Manuais

Manuais e produtos relacionados com Serras elétricas Grizzly G0614