Grizzly G0656 Manual do Utilizador descarregar pdf (Página 24)

-22-

G0656 8" Jointer with Built-In Mobile Base







Squaring stock involves four steps performed

in the order below:

1. Surface Plane On The Jointer—The con

cave face of the workpiece is surface planed flat

with the jointer.

Previously

Jointed Edge

Previously

Surface

Planed Face

2. Surface Plane On a Thickness Planer—The

opposite face of the workpiece is surface planed

flat with a thickness planer.

3. Edge Joint On The Jointer—The concave

edge of the workpiece is jointed flat with the

jointer.

4. Rip Cut On A Table Saw—The jointed edge

of the workpiece is placed against a table saw

fence and the opposite edge cut off.

Squaring Stock

The purpose of surface planing on the jointer is

to make one flat face on a piece of stock (see

Figures 26 & 27). This is a necessary step when

preparing a workpiece to be run through a planer

when squaring stock.

NOTICE

If you are not experienced with a jointer,

set the depth of cut to 0", and practice

feeding the workpiece across the tables as

described. This procedure will better pre

pare you for the actual operation.

Figure 27. Illustration of surface planing results.

Figure 26. Typical surface planing operation.

Surface Planing

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 51 52

Sem comentários

Grizzly G0656 Manual do Utilizador Página 24